News

Generally speaking, the temperature range of a hydromassage bathtub should be controlled between 37°C and 40°C, which is the most comfortable temperature for the human body and has ideal health benefits. It is recommended that the bathing time in warm water around 40°C should not exceed 15-20 minutes.

Since the hot tub heater is directly involved in the heating and circulation of water, it inevitably involves the water in the bathtub when replacing the heater. The replacement operation of the hot bathtub heater requires disconnecting the water pump and the pipe system, which usually means that the water needs to be drained to prevent water from overflowing or leaking during the operation.

The low temperature environment in winter poses many challenges to the operation of outdoor hot tubs, the most obvious of which is the rapid loss of water temperature and the potential risk of equipment damage. Therefore, covering the hot tub has become a key measure to protect the equipment and save energy.

Even if you need to have hydro massage frequently, make sure you have enough rest time between each massage. It is recommended to have a maximum of one hydro massage per day, with at least 24 hours between each massage. This allows the body enough time to recover and avoids overstimulating muscles and joints.

After adjusting the outdoor hot tub alkalinity, users need to give the water quality a certain amount of time to stabilize. Generally, you should wait at least 4 to 6 hours after adjusting the hot tub alkalinity before adjusting the pH. This is because when adding chemicals to adjust the alkalinity, the chemical reaction in the water takes a certain amount of time to complete.

The growth of algae is often accompanied by changes in the chemical composition of the hot tub water, such as increased hot bathtub pH and turbidity. Contact with water containing algae may cause discomfort to the eyes and respiratory tract, especially when other harmful microorganisms are present in the water.

The bathtub's filtration system will work for 30 minutes to 1 hour during the impact process to ensure that the water quality meets the hygienic standards. However, the length of the filtration time also depends on the chemical agents used, the type of disinfection system (such as ozone disinfection, ultraviolet disinfection, etc.) and the degree of water pollution.

Compared with traditional swimming pools, the water flow system of swim spa is more complicated, requiring precise water pumps, pipes and jet systems to ensure smooth water flow and sufficient pressure. The installation of these systems often involves the use of pipes.

If you use the whirlpool bathtub frequently every day or every week, the water and air flow in the jets will be more frequent, and the residual dirt will accumulate faster. For frequent users, it is recommended to clean the jets once a month to ensure smooth water flow and avoid clogging.

The maintenance of the ozone generator is relatively simple. Once installed, it is usually only necessary to regularly check the operation of the ozone generator and perform necessary cleaning and maintenance. Because ozone can reduce the use of other chemicals, ozone systems perform well in reducing chemical residues and maintaining water quality.