News

Reasons for poor insulation of outdoor whirlpool hot tub: 1. Poor quality or aging of insulation materials 2. External environmental influences 3. Failure of heat pump or heater 4. Problems with tub structure design 5. Water quality problems

When shampoo enters the bathtub, its ingredients will mix with other impurities in the water. Since the ingredients of shampoo are generally chemical surfactants, these ingredients may cause damage to the filter of the outdoor whirlpool hot tub. The chemicals in the shampoo may adhere to the surface of the filter, gradually forming residues, reducing its filtration efficiency and causing increased maintenance costs.

During the transportation and installation process of a new whirlpool hot tub, there may be some process residues, impurities or scale inside the pipes. Shock treatment helps clean the pipe system and the inside of the equipment to prevent these residues from adversely affecting the system.

Biofilm is a common phenomenon in aquatic environments. It is a sticky structure composed of organic substances such as polysaccharides and proteins secreted by microorganisms (such as bacteria, algae or fungi). These microorganisms can attach to the pipes, nozzles, filters and other parts of the whirlpool hot tub to form a layer of mucus.

In fact, the answer is: it can be both hot and cold, depending on the user's needs and the environmental conditions when using it. In most cases, outdoor whirlpool spa tubs are operated using hot water. Hot water whirlpool spa tubs use a built-in heating system to heat water to a suitable temperature, usually between 37°C and 40°C.

Baking soda dosage formula Based on empirical data, it takes about 1.5 pounds (about 680 grams) of baking soda to increase the alkalinity by 10 ppm for every 10,000 gallons of water. A 500-gallon outdoor whirlpool hot tub requires 170 grams of baking soda.

Calcium oxide cleaner is a professional scale cleaner commonly used in outdoor whirlpool hot tubs and swimming pools. It is suitable for removing mineral accumulation in water, including scale and rust. This type of cleaner usually dissolves in the bathtub water and helps remove scale and rust through chemical reactions.

The roller bearing of the outdoor whirlpool hot tub is responsible for supporting the rotating parts. If the bearing fails, it will cause abnormal friction noise, especially when the water flows through the nozzle and massage system.

Bacteria are one of the most common health risks in spa bathtubs, especially in the environment of outdoor whirlpool hot tubs, because its humid and hot characteristics provide ideal conditions for the growth of bacteria. One of the most common bacteria is Pseudomonas aeruginosa, which is particularly active in hot tub water.

If the outdoor whirlpool hot tub water temperature is high and the air temperature is also high, the chlorine may evaporate in just a few hours to a day. For example, over the course of a day's use, the water surface exposed to the air will accelerate the evaporation of chlorine, especially if the hot tub is not covered after use.

In general, it is necessary to test the outdoor whirlpool hot tub water quality at least once a week. This applies to most whirlpool hot tubs for home and private use. Testing once a week can help detect water quality problems such as high or low pH, insufficient chlorine content, etc. in time.

Although there is a possibility of virus transmission, it does not mean that it will definitely spread in large quantities in the water. In fact, the risk of herpes transmission in an outdoor whirlpool hot tub is not high. The key is whether there is an opportunity for direct contact with an infected person.