News

The main reason a spa hot tub tends to accumulate calcium and magnesium scale is the type of hard water supply in the area. International standards identify total hardness below 60 mg/L as soft water and total hardness exceeding 180 mg/L as being in a hard water area.

One might be tempted to conclude that the spa hot tub isn't working properly after noticing that it stays at 84°F. To prevent such a mistake it is best to check the operating mode that currently is displayed on the control panel - maybe the economy or the sleep mode has been set by accident.

Based on after-sales maintenance experience, there are many reasons for nozzle pulsation in outdoor hot tubs, but the most common is still insufficient water supply. When the massage pump cannot continuously obtain enough water, a situation similar to "insufficient fuel supply" in a car engine occurs.

Strictly speaking, sunlight doesn't directly alter the water quality of an outdoor spa hot tub like adding chemicals, but it indirectly affects the water balance through various physical and chemical processes, ultimately leading to changes in water quality.

The Most Common Reason for Automatic Start-up: Hot Tub Filter Circulation Program This is the real reason why the vast majority of users encounter automatic start-up. To maintain the cleanliness of the water in an outdoor hot water bath, the equipment needs to circulate and filter daily.

While yeast does thrive in warm, humid environments, modern outdoor hot tubs, if properly maintained, typically maintain a suitable concentration of disinfectants, such as chlorine or bromine, in the water. These disinfectants inhibit not only bacteria but also most microorganisms, including yeast.

Recent research into hydrotherapy has grown significantly; many medical institutions and rehabilitation centers now use water therapy as an adjunct treatment to relieve muscle fatigue, improve joint mobility, boost blood circulation, and reduce mental stress.

Upon encountering this, many users initially suspect a defect in the spa hot tub shell or assume the acrylic surface is aging, wearing down, or delaminating. In reality, this "sandpaper feel" is rarely caused by the tub material itself; instead, it is usually the result of accumulated calcium scale.

First, check if the water level in the whirlpool hot tub is within the normal range. If the level is low, immediately add clean water and restart the massage system to see if the jets resume operation.

Cloudy water is one of the most common and obvious warning signs. Healthy spa hot tub water should generally be clear and transparent, allowing you to easily see the structure of the bottom and the outlines of the jets. If you notice the water turning slightly milky, hazy, or losing clarity—even without a noticeable odor—you should be alert.

Many nozzles contain rotating internal components. To achieve effects such as pulsating massage, rotating massage, or multi-angle spraying, some whirlpool hot tubs employ rotating nozzle cores. These components undergo continuous, slight rotation or vibration during operation.

To better understand this relationship, consider the following example: A household outdoor hot tub has a capacity of 2,000 liters, with a measured pH of 8.1 and total alkalinity of 100 ppm. Based on standard guidelines, an initial dose of approximately 60 to 70 mL of hydrochloric acid can be added.