News

After a day of work and life pressure, the night is the time for most people to relax. The outdoor hot tub itself can help relax muscles and soothe tense nerves through hot water and massage functions, and the quietness and privacy of the night make this relaxation effect more significant.

Hot tub shock treatment is characterized by rapidity and efficiency, and is usually carried out when there are signs of deterioration in water quality. Even users who use chemical disinfectants (such as chlorine or bromine) or are equipped with ozone generators on a daily basis need to perform shock treatment regularly.

While hot tub massage jets are designed to run for long periods of time, they are not usually designed to work around the clock. Long-term operation will cause greater loads on the pump, motor, and filtration system, so leaving it on overnight may affect the life of the device.

Heating efficiency is one of the most important factors that users are concerned about when heating a hot tub. When the jet is running, it can indeed help to distribute heat more evenly in the water by accelerating the water flow and promoting water agitation.

A hot tub without a cover will lose a lot of heat, and the heating system will have to start more frequently to maintain the water temperature. Even if the cover is not used for only a short interval, the heat loss is still significant. For those who want to save money on their electricity bills, always using a hot tub cover is a simple and effective energy saving measure.

Since the hot tub heater is directly involved in the heating and circulation of water, it inevitably involves the water in the bathtub when replacing the heater. The replacement operation of the hot bathtub heater requires disconnecting the water pump and the pipe system, which usually means that the water needs to be drained to prevent water from overflowing or leaking during the operation.

The low temperature environment in winter poses many challenges to the operation of outdoor hot tubs, the most obvious of which is the rapid loss of water temperature and the potential risk of equipment damage. Therefore, covering the hot tub has become a key measure to protect the equipment and save energy.

After adjusting the outdoor hot tub alkalinity, users need to give the water quality a certain amount of time to stabilize. Generally, you should wait at least 4 to 6 hours after adjusting the hot tub alkalinity before adjusting the pH. This is because when adding chemicals to adjust the alkalinity, the chemical reaction in the water takes a certain amount of time to complete.

The growth of algae is often accompanied by changes in the chemical composition of the hot tub water, such as increased hot bathtub pH and turbidity. Contact with water containing algae may cause discomfort to the eyes and respiratory tract, especially when other harmful microorganisms are present in the water.

The bathtub's filtration system will work for 30 minutes to 1 hour during the impact process to ensure that the water quality meets the hygienic standards. However, the length of the filtration time also depends on the chemical agents used, the type of disinfection system (such as ozone disinfection, ultraviolet disinfection, etc.) and the degree of water pollution.

Compared with traditional swimming pools, the water flow system of swim spa is more complicated, requiring precise water pumps, pipes and jet systems to ensure smooth water flow and sufficient pressure. The installation of these systems often involves the use of pipes.

The maintenance of the ozone generator is relatively simple. Once installed, it is usually only necessary to regularly check the operation of the ozone generator and perform necessary cleaning and maintenance. Because ozone can reduce the use of other chemicals, ozone systems perform well in reducing chemical residues and maintaining water quality.