News

Step 1: Turn off the power and water sources Step 2. Empty the hot water bathtub Step 3: Check the source of the leak Step 4: Fix the leak Step 5: Re fill and test

Modern outdoor hot water tubs are usually equipped with an induction temperature control system that uses temperature sensors to monitor water temperature. These sensors are usually installed inside hot water tubs to ensure accurate measurement of water temperature. Some advanced hot water tubs even use multiple sensors to ensure uniform temperature distribution throughout the entire bathtub.

1. Power off and turn off the hot tub: 2. Find the filter location: 3. Remove the filter: 4. Clean the filter: 5. Soaking filter: 6. Rinsing and drying: 7. Reinstall the filter: 8. Restart the hot tub:

In some spa hot tubs, water is fed into the heater and heated by an electric or gas heater to maintain the selected comfortable temperature. The hot water will continue to flow until it enters the next stage.

It is crucial to regularly replace the water in outdoor hot tubs to ensure clean and hygienic water quality. However, when replacing water, do not waste valuable resources. You can use old water to water gardens or plants, thereby minimizing water waste.

Thoroughly cleaning and maintaining outdoor hot bathtubs at regular intervals is the key to preventing odors. Use the manufacturer's recommended cleaning products and methods to clean the interior and exterior surfaces of outdoor hot water tubs, including filters, pipes, and nozzles. Regular replacement of filters is also important to ensure clear water quality.

Water quality testing: Regular water quality testing is very important. The test results will tell you the pH value, concentration of bromine or chlorine, alkalinity, etc. in the water. If the test results show poor water quality, you may need to take measures to correct the problem, including replacing some or all of the water.

Install a custom sunshade or canopy to protect the outdoor hot bathtub from the effects of sunlight, rain, and snow. This can extend the service life of the hot tub while providing a rest area that is shaded and rainproof.

Connect a long hose to the outdoor hot tub drain pipe, which is usually located at the bottom of the hot bathtub. Ensure that the hose is securely connected to prevent water leakage. Open the other end of the hose to allow water to flow out. If you are using a water pump, please insert it into the outdoor hot tub and connect the hose to the water pump to start the pump to speed up the drainage process.

Regular testing of water quality parameters: Use water quality testing tools to regularly check the key parameters of SPA water, including pH value, residual chlorine, total alkalinity, and calcium hardness. These parameters affect the pH value, disinfection effect, and hardness of water, and are crucial for water quality. Adjust pH value: Ensure that the pH value of SPA water is within the appropriate range, usually between 7.2 and 7.8.

Use the pH test strip or digital tester in the outdoor hot tub test kit to measure the pH value in the hot tub. The goal is to maintain a pH value between 7.2 and 7.8.